M10 Hardware Design
1 Introduction
This document defines and specifies the M10 module series. For detail product information,
please refer to the chapter 6
Product Information.This document describes the hardware interface
of the Quectel’s M10 module series that connects to the specific application and the air interface.
This document can help you quickly understand module interface specifications, electrical and
mechanical details. With the help of this document and other M10 application notes, user guide,
you can use M10 module to design and set up mobile applications quickly.
1.1 Related documents
Table 1: Related documents
SN Document name Remark
[ 1 ] M1 0 _ AT C AT c o mma n d s s e t s
[2] ITU-T Draft new
recommendation
V.25ter:
Serial asynchronous automatic dialing and control
[3] GSM 07.07: Digital cellular telecommunications (Phase 2+); AT command
set for GSM Mobile Equipment (ME)
[4] GSM 07.10: Support GSM 07.10 multiplexing protocol
[5] GSM 07.05: Digital cellular telecommunications (Phase 2+); Use of Data
Terminal Equipment – Data Circuit terminating Equipment
(DTE – DCE) interface for Short Message Service (SMS) and
Cell Broadcast Service (CBS)
[6] GSM 11.14: Digital cellular telecommunications system (Phase 2+);
Specification of the SIM Application Toolkit for the Subscriber
Identity module – Mobile Equipment (SIM – ME) interface
[7] GSM 11.11: Digital cellular telecommunications system (Phase 2+);
Specification of the Subscriber Identity module – Mobile
Equipment (SIM – ME) interface
[8] GSM 03.38: Digital cellular telecommunications system (Phase 2+);
Alphabets and language-specific information
[9] GSM 11.10 Digital cellular telecommunications system (Phase 2) ；
Mobile Station (MS) conformance specification； Part 1:
Conformance specification
[10] GSM_UART_AN The document of UART port application notes
[11] M10_HD_AN01 The document of M10 hardware design application notes
M10_HD_V1.00 - 8 -
To Next Page
Loading...
Need help?
General
