5G Module Series
RM520N-GL_Hardware_Design 18 / 84
HPUE is only for single carrier.
5G NR FDD bands only support 15 kHz SCS, and NR TDD bands only support 30 kHz SCS.
See document [1] for bandwidth supported by each frequency band in the NSA and SA modes.
The maximum rates are theoretical and the actual values refer to the network configuration.
525 Mbps is the typical value; while 550 Mbps is the theoretical data rate when the UL 256QAM of both LTE and 5G NR
are enabled (LTEUL 256QAM in EN-DC is disabled by default and has not been deployed by operators, and it is not fully
tested).
⚫ 5G NR bands: Class 3 (23 dBm ±2 dB)
⚫ 5G NR n38/n40/n41/n77/n78/n79 bands HPUE: Class 2 (26 dBm +2/-3 dB)
⚫ LTE bands: Class 3 (23 dBm ±2 dB)
⚫ LTE B38/B41/B42/B43 bands
HPUE
1
: Class 2 (26 dBm ±2 dB)
⚫ WCDMA bands: Class 3 (24 dBm +1/-3 dB)
⚫ Supports 3GPP Rel-16
⚫ Supported modulations:
- Uplink: π/2-BPSK, QPSK, 16QAM, 64QAM and 256QAM
- Downlink: QPSK, 16QAM, 64QAM and 256QAM
⚫ Supports SCS 15 kHz
2
and 30 kHz
2
⚫ Supports SA
3
and NSA
3
operation modes
on all the 5G band
⚫ Supports Option 3x, 3a, 3 and Option 2
⚫ Max. transmission data rates
4
:
NSA: 3.2 Gbps (DL)/525/550
5
Mbps (UL)
SA: 2.4 Gbps (DL)/ 900 Mbps (UL)
⚫ Supports 3GPP Rel-16
⚫ LTE Category:
DL Cat 19/ UL Cat 18
⚫ Supported modulations:
- Uplink: QPSK, 16QAM and 64QAM and 256QAM
- Downlink: QPSK, 16QAM and 64QAM and 256QAM
⚫ Supports 1.4/3/5/10/15/20 MHz RF bandwidth
⚫ Max. transmission data rates
4
:
LTE: 1.6 Gbps (DL)/ 200 Mbps (UL)
⚫ Supports 3GPP Rel-9 DC-HSDPA, HSPA +, HSDPA, HSUPA and WCDMA
⚫ Supports QPSK, 16QAM and 64QAM modulation
⚫ Max. transmission data rates
4
:
- DC-HSDPA: 42 Mbps (DL)
- HSUPA: 5.76 Mbps (UL)
- WCDMA: 384 kbps (DL)/ 384 kbps (UL)
⚫ Supports 5G NR/LTE/WCDMA Rx-diversity
⚫ Protocol: NMEA 0183
⚫ Data Update Rate: 1 Hz
⚫ ANT0, ANT1, ANT2, and ANT3
⚫ Compliant with 3GPP TS 27.007 and 3GPP TS 27.005
⚫ Quectel enhanced AT commands
To Next Page
Loading...