297
Coffee brew
1. Remove the filter holder (c) from its seat, turning it clockwise.
2. Fill the filter with one or two doses of coffee (according to the filter inserted).
3. Press the coffee with the presser.
4. Place the filter holder (c) to its seat, turning it anti-clockwise.
5. Place the cups under the corresponding outlets under the filter holder.
6. Lift the coffee delivery lever (b) to the horizontal position to start the coffee
brew, and after a few seconds the coffee brew starts.
When the desired amount of coffee has been delivered, lower the group lever
to the vertical position.
Steam delivery
1. Wait for the heating light to switch on, then switch off (o) and make
sure that the pressure indicated on the boiler gauge (h) is more than 0.8 Bar.
2. Open the steam valve (d) for a few seconds and discharge a little steam into
the drip tray (i) then immerse the steam wand (e) in the liquid to be heated
and open the tap, when the required temperature is reached, close the tap.
After heating the beverage, always discharge a little steam from the wand to
clean the spray holes.
Hot water delivery
1. Place the container to collect the water under the hot water wand (g).
2. Open the water tap (f) to deliver the hot water.
3. When the required level is reached close the water tap.
Standby/Economy function
The Standby/Economy is used to set the machine in a condition of low
consumption by switching off the boiler heating resistor.
The machine automatically sets in Standby/Economy after 20 minutes if no coffee
is delivered.
When the machine is in Standby/Economy, the relevant LED (t) flashes every 2
seconds.
To exit from Standby/Economy, just deliver a coffee with the lever.
To Next Page
Loading...
