337
6. INSTALLATION
The machine is shipped ready for installation in accordance with the data found
rating plate.
Ensure that the machine specifications comply with those of the local electrical
power supply.
The electrical system must be equipped with an efficient residual current device
or an automatic circuit breaker with an efficient earthing system. In the event no
electrical safety device is present, have a qualified technician install a two-pole
rocker switch/thermal-magnetic circuit breaker as required by current safety
regulations.
Proper earthing of the device is mandatory.
The manufacturer declines all responsibility in the event this health and
safety regulation is not respected.
Be careful not to damage the power supply cable by bending, crushing or
stresses.
Do not disconnect the machine power supply by pulling the cable, disconnect by
gripping the plug.
It is recommended to avoid positioning the machine in tight spaces or avoid
disruption to its operation, supply or maintenance.
• The surface where the machine is to be installed must be level, dry, durable
and stable, and at a height of 80 cm from ground.
• Position the machine and connect the power supply cable to the electrical
socket.
Water connection model 0993
The machine is prepared for water connection. Contact your
dealer to purchase the appropriate KIT
Ensure that the water supply line is connected to a cold drinking water network
with a maximum pressure of 0.6 MPa.
Before connecting the machine to the water mains, we recommend draining some
water from the mains to remove any impurities in the system.
Under the base of the machine there is a 3/8 "G fitting for connection to the water
mains: connect the hose and gaskets provided.
To Next Page
Loading...
Need help?
General
