302
Coffee brew
1. Remove the filter holder (c) from its seat, turning it clockwise.
2. Fill the filter with one or two doses of coffee (according to the filter inserted).
3. Press the coffee with the presser.
4. Place the filter holder (c) to its seat, turning it anti-clockwise.
5. Place the cups under the corresponding outlets under the filter holder.
6. Lift the coffee delivery lever (b) to the horizontal position to start the coffee
brew, and after a few seconds the coffee brew starts. When the desired
amount of coffee has been delivered, lower the group lever to the vertical
position.
Steam delivery
1. Wait for the heating light to switch on, then switch off (o) and make
sure that the pressure indicated on the boiler gauge (h) is more than 0.8
Bar.
2. Open the steam valve (d) for a few seconds and discharge a little steam
into the drip tray (i) then immerse the steam wand (e) in the liquid to be
heated and open the tap, when the required temperature is reached, close
the tap.
After heating the beverage, always discharge a little steam
from the wand to clean the spray holes.
Hot water delivery
1. Place the container to collect the water under the hot water wand (g).
2. Open the water tap (f) to deliver the hot water.
3. When the required level is reached close the water tap.
To Next Page
Loading...
Need help?
General
