EasyManua.ls Logo

Quick MILL ELEVATE R - Page 315

Quick MILL ELEVATE R
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
315
Italiano
English
Français
Deutsch
It is recommended to be very careful of the machine hot parts, especially the
delivery group and the steam pipe. Never place the hands under the steam pipe
and/or the group when carrying out the relevant operations.
Steam delivery
1. Activate the steam delivery for a few seconds with the knob (d) and discharge
the condensation formed in the steam pipe into the drip tray (l) then close the
steam delivery.
2. Immerse about half the steam wand (e) in the brew to be heated, start the
steam delivery again with the knob. When the required temperature is
reached, close the knob.
It is advised, after heating the beverage, to always discharge a little
steam from the wand to clean the spray holes.
Hot water delivery
1. Place a container to collect the water under the hot water distributor, then
open the tap (f) and close it when the required water level is reached.
Standby/Economy function
The Standby/Economy is used to set the machine in a condition of low
consumption by switching off the boiler heating resistor.
The machine automatically sets in Standby/Economy after 20 minutes if no coffee
is delivered.
When the machine is in Standby/Economy, the relevant LED (s) flashes every 2
seconds.
To exit from Standby/Economy, just deliver a coffee with the lever.

Table of Contents

Related product manuals