329
ThermoPID single temperature
Through one of the TermoPID models mounted, it is possible to adjust the
temperature of the machine boilers.
During normal operation, the display shows the current boiler temperature.
To set the temperature, proceed as follows.
Set-point temperature programming
To access the set point temperature adjustment programming, proceed as
follows:
• With thermopid enabled (on), press the▼ button.
• When the display shows "PrG" press the ▲ and ▼key to change the desired
boiler temperature set point.
• After 3 seconds after pressing the last key the data is stored and the display
shows the current temperature.
ECONOMY function
The Economy function on the SINGLE TEMPERATURE TERMOPID allows you
to turn off the boiler heating if no coffee is brewed after a programmable time of
10 to 240 minutes.
When the machine is in Economy mode, "ECO" appears on the thermoPID
display. When a coffee is brewed or a key is pressed on the display, the machine
exits Eco and starts heating again as if it were the first time it was switched on.
To enter and set the ECONOMY time, simply act as follows:
• With thermoPID enabled (on), press the ▼ key twice until the display shows
"ECO";
• Press the ▲ and ▼key to enter OFF and disable the function or enter the
minutes after which the ECONOMY function must be entered.
• Three seconds after pressing the last key the data is stored and the display
shows the current temperature.
To Next Page
Loading...
Need help?
General
