5
Contents
using Signal Stalker I 51
trunking operation 51
setting the scanner to the
trunking mode 52
simultaneous trunking 52
setting squelch for the trunking
mode 52
programming trunked frequencies 53
searching a trunked bank 56
turning a trunked bank on or off 57
skipping a trunked bank 58
turning the status bit ignore
(s-bit) on or off 58
identifying a trunked frequency 59
selecting the EDACS (Ed) talk
group ID format 60
EDACS (Ed) talk group ID
range search 60
using HOLD to monitor an
active talk group ID 61
locking out talk group IDs 61
unlocking a single talk group ID 62
unlocking all talk group IDs 62
using trunk scanning Scan Delay 63
monitoring talk group IDs 63
using talk group ID lists 64
manually storing talk group IDs
in talk group ID lists 64
Motorola talk groups 65
To enter a Type 2 Talk Group ID: 65
To enter a Type 1 ID: 65
To Next Page
Loading...
