50
Beyond the Basics
Set S-S.LOG to ON to scan the log
channels along with the normal
channels. If you do not want to scan
the channels, set it to OFF.
The scanner stores signals found by
the Signal Stalker I even the S-S.LOG
function is OFF.
The frequencies in the log channels
are deleted when the scanner is
turned off.
3. Repeatedly press S or T to select the
option you want, then press E/PGM.
• S-S.bnd: If you selected S-S.bnd, one
of the following band names appears:
29-54 : VHF Low Band
108-137: AIR Band
137-225: VHF High Band
400-512: UHF Band
806-956: 800MHz Band
Repeatedly press S or T to select
the band you want to set, then press
E/PGM.
4. Repeatedly press S or T to select ON
or OFF, then press E/PGM.
To Next Page
Loading...
