Radio Shack Racing Scanner - Setup; Powering Your Scanner; Installing Batteries; Charging Ni-MH Batteries

7
Setup
Setup
Powering Your Scanner
YoucanpoweryourscannerwiththreeAAbatteries,orwithanAC
orDCadapter(noneincluded).Forlongestoperationandbest
performance,usealkalinebatteries,orusenickel-metalhydride
(Ni-MH)rechargeablebatteries.
Installing Batteries
1. Turnoffthescanner.
2. Removethebatterycompartment
cover.
3. Setthebatterytypeselectorswitch
insidethebatterycompartmentto
ALKfornon-rechargeablealkaline
batteriesorNi-MHforrechargeable
batteries.
4. InsertthreeAAbatteries,matching
thepolaritysymbols(+and–)
markedinside.
5. Replacethebatterycompartmentcover.
Charging Ni-MH Batteries
1. PressandholdPOWERtopoweroff
thescanner.
2. MakesureNi-MHbatteriesare
installedandthebatterytypeselectorswitchissettoNi-MH.
3. PluganACorDCpoweradapter(notsupplied;seepage8)into
thePWRjack.
4. Chargingindicatesthebatteriesarebeingcharged.
5. WhenCharge OFFappearsinsteadofCharging(about14
hoursforafullcharge),thebatteriesarefullycharged.
6. Disconnectthescannerfromthepowersource.
Ni-MH/ALK
Switch
AA
AA
AA