© 2014 Radiodetection Ltd 9
For more information about recharging batteries refer to
the instructions that came with your charger.
WARNING! Do not heat the rechargeable battery pack
above 60°C (140°F) as this will damage the battery’s
thermal fuses.
Recharging the transmitter Li-ion battery pack
To recharge the battery pack, remove the pack from the
transmitter and connect the transmitter battery charger.
Figure 3.3 Charging the transmitter Li-ion battery pack
For more information about recharging batteries refer to
the instructions that came with your charger
Using the D-cell locator battery holder
The locator can also be powered by three D-Cell
Alkaline or NiMH batteries.
NOTE: When installing batteries always observe the
correct battery polarity as indicated on the battery tray.
Figure 3.4 Locator D-cell holder
To insert the D-cells:
1 Open the cell tray and insert 1 D-cell
2 Close the tray and insert 2 D-cells
To remove/fit a battery holder:
1 Open the battery compartment using the
release catch
2 Un-plug the battery lead connector (fig.3.1)
3 Lift the accessory cover slightly (fig 3.5)
Figure 3.5 Lifting accessory cover
To Next Page
Loading...
