RadioLink t8fb - 2.2.1 Software APP Installation on Computer; 2.2.2 Software APP Connection on Computer

RadioLink Electronic Ltd
www.radiolink.com
12
PART 3 T8FB Parameters Setup Via Android Smart-phone APP
New version T8FB that with USB upgrade port will support parameters setup via android smart-
phone APP.
3.1 Configuration
1) One USB cable for Android smart-phone
The smaller port connect to T8FB USB port and the other bigger port connect to OTG data cable.
2) One OTG cable for Android smart-phone
The smaller port connect to smart-phone USB port
3) Android smart-phone system requires to upgrade to version 4.0 or above. Attention:This APP do
not support iPhone now.
3.2 APP Installation
1) Download the“RadiolinkT8FB(en).APK” software to your phone (please
download from our website www.radiolink.com, click the software to
install, or scan this QR code to download.
2) Click “Done” when APP have installed, you will see the T8FB parameter
setting APP on smart-phone interface, if you click “open“, the APP will
open directly.
3) You can find out the installation steps as below