RadioLink Electronic Ltd
www.radiolink.com
21
3.5 FAQ
1) What is the order of the connections for APP--USB--T8FB ?
The best order is: Turn on T8FB -- connect USB cable-- connect APP.
When you connect the APP, the phone will prompt that open APP.
2) Why the prompt box always be showed ?
Just make sure the key steps are right. There are some prompt box when you change from one
function interface to other.
3) Why the voltage data is always move up or down when T8FB connect to APP, sometime is 0,
sometime is 7.98v ?
Just close the APP, then reconnect again will solve this problem.
4) Why the APP show the flashback reminder?
Please contact our sales-after service, there’s maybe something wrong with the APP, we will send
you a upgrade software to solve this problem.
5) What are the correct steps for the “READ”?
In general, please click the “READ” first after connect T8FB to APP to make sure the data of APP is
the default data or you setup last time.
6) How to restore factory settings?
When the APP opened (don’t READ ), the current data is factory setting data, you just need to push
the “UPDATE” button, so restore the factory setting.
7) How to solve the problem if the APP always can not connect to T8FB?
Maybe there is something wrong with the android USB cable, if not, please contact our after-sales
service.
To Next Page
Loading...
Need help?
General
