RadioLink Electronic Ltd
www.radiolink.com
20
0% means a output signal 1ms, and 100% means 2ms. You can totally get 6 different modes by
adjusting the related rates.
“ELEVON”: Adjust the aileron distance, allow aileron differential.
ADJUSTABILITY:
• Requires use of CH1 and CH2.
• Independently adjustable aileron travel allows aileron differential.
• Independently adjustable elevator travel allows for differences in up vs. down travel.
• The separate ELEVON settings for each condition can be set. (GLID only)
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set
up after pressing DIAL for 1 second and canceling an alarm display. (GLID only)
Note: Be sure to move the elevator and aileron sticks to full deflection during setup. If large travels
are specified, when the AILERON and ELEVATOR STICKS are moved at the same time the controls
may bind or run out of travel.
“V-TAIL”: Be used on the V-ail aircraft.
V-TAIL mixing is used with v-tail aircraft so that both elevator and rudder functions are combined
for the two tail surfaces. Both elevator and rudder travel can be adjusted independently on each
surface.
Note: NOTE: If V-TAIL is active, you cannot activate ELEVON or AILEVATOR functions. If one of
these functions is active, an error message will be displayed and you must deactivate the last
function prior to activating ELEVON.
Note: Be sure to move the elevator and rudder sticks regularly while checking the servo motions. If a
large value of travel is specified, when the sticks are moved at the same time, the controls may bind
or run out of travel. Decrease the travel until no binding occurs.
Adjustability:
• Requires use of CH2 and CH4.
• Independently adjustable travels allow for differences in servo travels.
• Rudder differential is not available. (To create rudder differential, set RUD1 and 2 to 0, then
use two programmable mixes, RUD-ELE and RUD-RUD, setting different percents for up and down.
These are your new rudder travels. Trim and link off, switch assignment null so you can ’ t
accidentally turn off rudder.
4)“SYSTEM”: Have three buttons “AUX-CH” “PROG.MIX1” “PROG.MIX2”
To Next Page
Loading...
Need help?
General
