RadioLink Electronic Ltd
www.radiolink.com
1
Thank you for purchasing Radiolink 2.4 GHz remote control system T8FB .
To fully enjoy the benefits of this product and ensure safety, please read the manual carefully
and set up the device as instructed steps.
If any problems found during the operation process, either way listed below can be used as
online tech support.
1. Send mails to after_service@radioLink.com.cn or after_service1@radioLink.com.cn and we will
answer your question at the earliest.
2. PM us on our Facebook page or leave comments on our Youtube page
3. If the product is purchased from RadioLink AliExpress Global or Amazon U.S , you can contact
after-sales service directly.
4. If the product is purchased from the local distributor, you can also ask them for support and
repair as prefer.
All manuals and firmwares are available on RadioLink official website www.radiolink.com and more
tutorials are uploaded. Or follow our Facebook and Youtube homepage to stay tuned with our latest
news.
SAFETY PRECAUTIONS
Never operate your model during adverse weather conditions. Poor visibility can cause
disorientation and loss of control of your model.
Never use this product in a crowd and illegal area.
Always ensure the trim levers at 0 and battery properly charged before connecting the receiver.
Always check all servos and their connections prior to each run.
Always be sure about turning off the receiver before the transmitter.
WARNING
This product is not a toy and is NOT suitable for children under the age of 18. Adults should
keep the product out of the reach of children and exercise caution when operating this product in
the presence of children.
Water or moisture may enter the transmitter inside through gaps in the antenna or joystick and
cause model instability, even out of control. If running in the wet weather(such as game) is inevitable,
always use plastic bags or waterproof cloth to cover the transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1
This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.