RadioLink Electronic Limited
www.radiolink.com
10
Note: If the driver is installed normally, but the COM port connected to T8S cannot be detected, you
could try to another USB data cable. Do not use USB charging cable.
③ T8S will continuously make D sounds, press any of the trimmer buttons (Go to page 3 to see the
location of trimmer buttons) to stop the DD sounds.
READ: Click READ, two short D sounds will be heard and the APP starts reading the data in T8S. Every
time the APP is reopened, the data displayed is the initial default value. If the parameters are modified, you
need to click to “READ” again to display the modified data.
WRITE: Click “WRITE” and three slow D sounds mean the modified data have been written successfully.
If no D sound means update failure, please reconnect T8S to the APP and re-write. Click “WRITE” each time
parameter is modified to make sure it’s well input to the T8S.
LOAD: Click LOAD and a pop out of ‘Model Select’ will display. If there is no successfully stored data,
there will be no display. Besides, user also can create a new file or select among the saved files.
SAVE: Click to save the APP data as a file in the computer.
To Next Page
Loading...
Need help?
General
