RadioLink T8S(BT) User Manual

RadioLink Electronic Limited
www.radiolink.com
20
3.3.4 V-TAIL
V-TAIL used for fixed wing with v-tail. Two servos can control two servos surfaces that on the left and
right sides of the aircraft separately, and operate aileron function and elevator function.
When “MIX” is set from “INH” to “ON”, the “ELEV “and “RUDD “function is turned on. When this
function is turned on, then both CH2 and CH4 will respond, and servo travel range can be adjusted
individually.
The interface of parameter setup APP on phone
ELEV 1 and RUDD 2 correspond to the response rate of channel 2 when performing elevator operation
and rudder operation.
ELEV 2 and RUDD 1 correspond to the response rate of channel 4 when performing elevator operation
and rudder operation.
The specific value is the amount of servo travel range when the corresponding channel performs the
elevator or rudder operation. Positive and negative values represent different directions of movement.
The interface of parameter setup software on computer

RadioLink T8S(BT) Specifications

General

Brand	RadioLink
Model	T8S(BT)
Category	Remote Control
Language	English