RadioLink Electronic Limited
www.radiolink.com
15
3.2.4 FAIL SAFE (F/S)
If the flight has reached the limit control distance, there is strong interference in the flight area, there
are obstacles between the transmitter and the receiver, or T8S low voltage it will cause loss of control. At
this time, you can set the Fail-Safe, so that the model can maintain working at the F/S value you set after
loss of control. F/S needs to be set in advance. Each channel can be set independently.
According to your needs, set the servo travel range output by the channel. After setting it, the receiver
will continue to output the servo travel range according to the value you set when the receiver loses the
control of transmitter.
The interface of parameter setup APP on phone.
The interface of parameter setup software on computer.
Note:
1.The setting of the throttle F/S also applies to the low battery voltage. F/S value 0 means throttle stick
at the lowest point while 50 means at the central point.
2.The F/S (Fail-safe) function can be used in certain competitions to ensure safe landing of the model
prior to flying away and dropping. Besides, it can also be used make all servos neutral to maximize the flight
time.
To Next Page
Loading...
Need help?
General
