RadioLink Electronic Limited
www.radiolink.com
17
3.3 ADVANCED Menu
3.3.1 D/R (Dual Rate)
The model can be controlled to work on different servo travel range by a switch. Before using this
function, set the state of “Mix” from “INH” to “ON”.CH1/2/3/4 can be chosen to set separately. the switch
can be set to SWA or SWB. “Up” and “Down” correspond to the positions of switch. The value of “Up” and
“Down” is maximum servo travel range you set.
DR/CURE: It’s an index. When it is not set, the value defaults to 0, and the output servo travel range of
the corresponding channel will be output in proportion to the move of the joystick. The value can be set
from -100% to +100%. The change of the index will not change the maximum and minimum servo travel
range. When controlling the aircraft, the index setting value is usually negative.
⚫ When the index is a negative value, the greater the negative value, the lower the sensitivity of the joystick
in the neutral position and the higher the sensitivity at both ends position.
⚫ When the index is a positive value, the greater the positive value, the higher the sensitivity of the joystick
in the neutral position, and the lower the sensitivity at both ends position.
The interface of parameter setup APP on phone.
The interface of parameter setup software on computer.
To Next Page
Loading...
Need help?
General
