RadioLink Electronic Limited
www.radiolink.com
22
3.3.6 TH/CURE
Throttle curve (TH/CURE) is the set output travel by throttle. It is to coordinate the motor response
and the throttle operation. The horizontal ordinate is the joystick position while the vertical ordinate is the
throttle output.
When “TH-SW” is set from “OFF” to “ON”, the throttle curve function is turned on. Adjust the value of 7
points. The adjustable range is from 0 to 100. The larger the value it is, the larger the output throttle is when
the throttle joystick moves to the corresponding position.
The interface of parameter setup APP on phone(SYSTEM)
The interface of parameter setup software on computer (Advanced Menu 3)
3.4 SYSTEM Menu
3.4.1 ALARM SETTINGS
TX-ALARM (SYSTEM and SYSTEM 2)
The transmitter alarm voltage can be set in the SYSTEM and SYSTEM 2. The default remote controller
alarm voltage of the T8S transmitter is 3.7V and cannot be modified. When the transmitter voltage is lower
than 3.7V alarm value, T8S will make D sound to warn.
To Next Page
Loading...
Need help?
General
