RadioLink Electronic Limited
www.radiolink.com
23
EXT-ALARM(SYSTEM2)
The default EXT battery alarm voltage of the T8S is 11V. You can set different alarm voltages value for
batteries with different number of cells to protect EXT-battery.
We suggest that 7.4V set for 2S lithium battery, 11.1V set for 3S lithium battery, 14.8V set for 4S lithium
battery. When the model voltage goes lower than the set value, T8S will make D sound to warn.
Note To use this function, Radiolink R7FG or R8F receiver that supports voltage return function is required.
RSSI-ALARM(SYSTEM2)
The default signal strength alarm value of the T8S is -100dBm. You can set a reasonable value according
to the actual situation to prevent the model from losing control due to weak signal. When the RSSI goes
lower than value you set, T8S will make D sound to warn.
The best RSSI-ALM is depends on the control range test at your flying area. For example, you have tested
the control distance of your T8S is 2000 meters at your flying area, and the RSSI shows -86dBm at this time,
then you can set the RSSI alarm data is -86dBm.
If you have no time to have a range test, the 80-86 dBm is suggest to set for RSSI-ALM.
The interface of parameter setup APP on phone (The EXT-Alarm and RSSI-Alarm only can be set on
the mobile phone APP.)
The interface of parameter setup software on computer
To Next Page
Loading...
Need help?
General
