RadioLink TrackStar D-Spec TS4G - ABS Function

17
function.
2. Press “Enter” button to get into THSPD function interface.
3.If initial MODE setup item is SPEED1,{ if initial MODE setup item is SPEED 2 or
OFF, you need to select SPEED 1 by pressing “Dec(-)” or “ Inc(+)” button to select
MODE setup item , then press “Enter” key, SPEED 2 or OFF will blink, press
“Dec(-)” or “Inc(+)” button, when the blinking SPEED 2 or OFF change to blinking
SPEED 1, press “Enter” key, SPEED 1 will stop blink, now SPEED 1 is selected},
press “Dec(-)” or “Inc(+)” button to select ALL set up item, then press “Enter” key,
the initial value will blink,use “Dec(-)” or “Inc(+)” button to adjust the delay of the
entire throttle forward side range.
(Note: In the interface of adjusting the value, return to the initial value"100" by
pressing “Dec(-)” and “Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, nowthe value has been set.
4.When ending setting, return to the initial screen by pressing “Exit” button twice.
Adjustment method for SPEED 2
Setup items
MODE:Speed type selection
LOW:Low side range speed adjustment
HIGH:High side range speed adjustment
TGP1:Low and medium speed switching point
Adjustment range
LOW:1~100
HIGH:1~100
At 100, there is no delay
TGP1:1~100
1.Enter the function menu and use “Dec(-)” or “Inc(+) ” button to access THSPD
function.
2.Press “Enter” button to get into THSPD function interface.