RadioLink TrackStar D-Spec TS4G - Subtrim SUBTR

25
1.Enter the function menu and use “Dec(-)” or “Inc(+) ” button to access IDLUP
function.
2.Press “Enter” button to get into IDLUP function interface.
3.Press “Enter” key, and the initial value of
RATE
will blink. Use “
Dec(-)
” or
“Inc(+)” button to adjust the value.
(Note: In the interface of adjusting the value,return to the initial value "
0%
"by
pressing “Dec(-)” and “Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter”button,the adjusted value stops blinking,now the value has been set.
4.When ending setting, return to the initial screen by pressing “Exit”button twice.
Servo center position ne adjustment
Use this function to adjust the neutral position of the steering,throttle and channel 3
servos.
Channel
ST:Steering
TH:Throttle
CH3:Channel3
CH4:Channel4
Subtrim
ST:L100~R100
TH:B100~F100
CH3:-100~+100
CH4:-100~+100
Initial value : 0
1.Enter the function menu and use “Dec(-)” or “Inc(+)” button to access SUBTR
function.
2.Press “Enter” button to get into SUBTR function interface.
Subtrim "SUBTR"