5
Power standard：6VDC (1.5AA*4)
RF power：less than 10dbm
Power extending: JST port 2S~3S
LiPo/LiFePo battery
Modulation: FHSS
Low voltage alert：Yes（lower than 4.6V）
Data resolution：2048
Frequency：2.4GHz
RF range: 300meters on ground
Failsafe: in 1 second receiver fail getting signal from TX, the throttle will be 0, servos
keep the last status.
Receiver’s connection and installation：（such as some car model）
NOTICE：
1． Confirm battery, switch, servos and etc are connected with receiver right.
2． While installing servos, please keep servo’s distance from model body,
otherwise the vibration can lead to servo and make servo damaged.
3． After installation of servos, please try to control the servo to full if it
got stuck or sounded abnormal, you must solve the problem. Even if servo
Receiver installation and binding
* RC3S standard equipment:A transmitter and a R4EH-H receiver.
* RC4G standard equipment:A transmitter and a R4EH-G receiver.
To Next Page
Loading...
