RadioLink TrackStar D-Spec TS4G - Model Name Configuration

31
The channel 3 and channel 4 servo position can be set from the transmitter.When
CH3is assignedto the 3rd channel key,this setting is linked to the key.When CH3
and CH4 is not assigned to the 3
rd
channel key, it can be set with this screen.
You can also set the CH3 and CH4 as VR at the same time, or SW.
Channel 3 position (POSI)
-100~+100
Channel 4 position (POSI)
-100~+100
Initial value: 0
1.Enter the function menu and use
“Dec(-)”
or “Inc(+)” button to access AUX function.
2.Press “Enter” button to get into CH3 or CH4 function interface.
3.Use “Dec(-)” or “Inc(+)” button to select Channel setup item.
Use “Dec(-)” or “Inc(+)” button to select POSI, press “Enter”key and the value will
blink, use “Dec(-)” or “Inc(+)” button to select “VR” or “SW”.
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
RC3S/RC4G stores model memories for five models.Each model memory can be
named
separately according to user’s requirement.
Factory default name: MODEL5
1.Enter the function menu and use “Dec(-)” or “Inc(+)”
button to access NAME function.
2.Press “Enter” button to get into NAME function interface,
the first character of current name will blink, and the
blinking character can be reset. The common use
characters appear at the bottom of the screen, use
“Dec(-)” or “Inc(+)” button to choose the character you desired.Press“Enter” button
again, the next character of current name will blink. Reset other characters of current
name in same manner.
Model name "NAME"