RadioLink TrackStar D-Spec TS4G - Throttle Acceleration ACCEL

23
7. When ending setting, return to the initial screen by pressing “Exit” button twice.
Function which adjusts the movement
characteristic
from the
throttle
neutral position
The servo will jump to the input position at its maximum possible speed. Unlike
exponential, which adjusts the whole throttle movement into a curve, throttle
acceleration simply "jumps" away from neutral and then leaves the remaining
response linear.
Setup item
FWRD:Forward side acceleration amount
BRAK:Brake side acceleration amount
Throttle acceleration adjustment
Enter the function menu and use “Dec(-)” or “Inc(+)”
button to access ACCEL function, then press “Enter”
button to get into ACCEL function interface.
1.(Forward acceleration amount adjustment)
Press “Dec(-)” or “Inc(+)” button to select “FWRD”,press “Enter” key toconfirm
and the initial value of “FWRD” will blink,then use “Dec(-)”or“Inc(+)” button
adjust the acceleration amount.
(Note: In the interface of adjusting the value,return to the initial value "0"
by pressing
“Dec(-)” and “Inc(+)” buttons simultaneously for about 1 second.)
Press“Enter” button, the adjusted value stops blinking, now the value has been set.
"0":No acceleration
"100":Maximum acceleration(Approximately 1/2 of the forward side
steering
angle)
Forward acceleration amount(FWRD)
0~100
Throttle Acceleration "ACCEL"