71
B
INSTALLING THE WINDOWS OS
After all hardware components have been installed, you must first configure Intel South Bridge
RAID settings before you install the Windows operating system and other software drivers. To
configure RAID settings, refer to RAID configuration documentation.
Installing the Windows operating system to a RAID system
1. Insert the Windows operating system CD into the CD-ROM drive. The system starts booting
up from CD.
2. Press F6 when the message “Press F6 if you need to install a third party SCSI or RAID driver”
appears.
3. When the Windows setup screen appears, press S to specify additional device(s).
4. Insert the driver disk “Intel AA RAID XP/2003/2008/Vista Driver for ICH10R” into drive A
and press Enter.
5. Choose the Intel(R) ICH10R SATA RAID Controller from the list indicated in the Windows OS
Setup Screen, and press Enter.
6. Press Enter to continue the installation process.
If you need to specify any additional devices to be installed, do so at this time. Once all
devices are specified, press Enter to continue with the installation.
7. From the Windows setup screen, press Enter.
The Windows setup automatically loads all device files and then continues the operating
system installation.
8. After the operating system installation is completed, the system automatically reboots.
To Next Page
Loading...
