RADWAG AS series

13
9 Functions for calibration and weighing modes
- Counting pieces < PIECES>,
- Control +/- <HiLo>,
- Control of deviations % according to standard mass <Perc A>,
<Perc B>,
- Thickness of liquids <d_Li>or solids <d_Co>,
- Pipettes calibration <PiPEt>.
9 Choice of criteria of stable result depending on usage conditions
- Turn off/on system of autozero <AUTO>,
- Average result of weighing <AvE>,
- Back light function<bl>,
- Beep signal <bEEP>,
9 Function for using RS 232 (Esc/TARE key + print key)
- Choose speed of transmission,
- Define sent data as: stable / not stable,
- Continuous work,
- automatic work for RS 232.
Moreover balance can be used to weigh hang loads, print report of calibration,
check deviation of calibration and print reports of testing thickness of liquids and
solids.