35
11.3. Calibration test
11.3.1. Balances with internal calibration
Internal calibration mass is compared to its value in the balance memory.
This process is automatic. Its result is shown on the display. Process
proceeds automatically and display indicates its result (if balance is
connected to computer or to printer through RS 232 joint, printout of
calibration test will take place). Press ESC/TARA key to return to previous
screen.
Procedure:
Return to weighing
The changes are recorded when the balance returns to weighing
mode with the recording the changes. Press the ESC many times.
Following question appears on the display.
Select one of the options : ENTER – record / ESC – cancel
(Return to weighing 7.1.2. Return to weighing).
To Next Page
Loading...
