RADWAG AS series Operating Instruction

11
The balance with Φ 85 mm pan:
- open side doors of weighing
chamber,
- inside the chamber place
lower shield of weighing
chamber (1),
- inside the chamber place
anti-breeze shield (2),
- put centring ring on the shield
(3),
- put the balance pan inside
the ring (4),
- close side doors of weighing
chamber,
- turn on balance supply,
- pin of power adaptor should
be connected to socket in the
back of balance casing.
4.3. Positioning
Before switching on the balance, please level the device with
two adjusting feet situated at the back of the casing. Please
level the balance so that the air bubble of the level is placed
centrally.

RADWAG AS series Specifications

General

Display	LCD with backlight
Maximum Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Calibration	Internal or external, depending on model
Stabilization Time	≤ 3 seconds
Interface	RS232, USB
Repeatability (Standard deviation)	Varies by model
Linearity	Varies by model
Net Weight	Varies by model
Protection Class	IP 43