RADWAG AS series

64
14.3. Setting type of operating for RS 232 joint
Procedure:
rEPL no – manual operating / after pressing PRINT key
rEPL YES - automatic operating / after stabilization of weighing
result.
Return to weighing
(see - 7.1.2. – return to weighing).
Automatic operating takes place according to following scheme:
 press TARE key to zero the balance (display will indicate marker of
stable measurement and marker of zero)
 place the load, balance will send through the RS232 first stable
measurement
 remove load from the pan,
 next measurement will be possible when weighing result +/- 50
reading units referring to zero (by next measurement zero stat is not
required).