What to do if Rae Measuring Instruments reading abnormally high?
If your Rae Measuring Instruments are showing abnormally high readings, there might be several reasons. First, try replacing the filter if it's dirty. If that doesn't solve the problem, blow-dry the sensor module. Also, calibrate the unit. Note that excessive moisture and water condensation can also cause this issue.
What to do if Rae Measuring Instruments reading abnormally low?
If your Rae Measuring Instruments are showing abnormally low readings, there are a few potential causes. Start by replacing the dirty filter. Calibrate the unit. Remove the Calibration Adapter. Check for air leakage. Note that a dirty sensor module and a weak or dirty lamp can also cause this issue.
Why won't my Rae Measuring Instruments turn on after charging?
If your Rae Measuring Instruments won't turn on after charging, the battery may be discharged or defective. Try charging or replacing the battery.
What does the 'Lamp' message during operation of Rae Measuring Instruments mean?
If you see a 'Lamp' message during operation of your Rae Measuring Instruments, it could be due to the lamp drive circuit or a weak or defective PID lamp. Try turning the unit off and back on. If the problem persists, replace the UV lamp.
What to do if Rae Measuring Instruments buzzer is inoperative?
If the buzzer on your Rae Measuring Instruments is not working, first check that the buzzer is not turned off. For any further assistance, it is necessary to call an authorized service center.
How to fix low inlet flow in Rae Measuring Instruments?
If the inlet flow is too low in your Rae Measuring Instruments, it could be due to a damaged pump diaphragm, debris, or flow path leaks. Check the flow path for leaks, including the sensor module O-ring, tube connectors, and Teflon tube compression fitting.
Essential safety and operational guidelines before using the instrument.
Details intrinsic safety classifications and critical safety precautions for instrument use.
Step-by-step guide to installing and using AA alkaline batteries.
Detailed guide for performing zero and span calibration procedures.
Addresses issues like power, password, abnormal readings, flow, and lamp errors.
General| Brand | Rae |
|---|---|
| Model | MiniRAE Lite |
| Category | Measuring Instruments |
| Language | English |
To Next Page
