What to do if the buzzer, LEDs, or vibration alarm is inoperative on Rae ToxiRAE Pro?
If the buzzer, LEDs, or vibration alarm on your Rae Measuring Instruments isn't working, here are a few things to check: * First, ensure that the alarms are enabled in the 'Buzzer & Light' section of the 'Alarm Settings' sub-menu within the 'Programming' menu. * Also, check for any blockage of the alarm port and clear it.
Why is my Rae Measuring Instruments reading abnormally low?
An abnormally low reading on your Rae Measuring Instruments could be due to a Calibration Adapter being attached. Remove the Calibration Adapter. It may also indicate that the ToxiRAE Pro needs calibration; in this case, calibrate the device.
General| Type | Portable Gas Detector |
|---|---|
| Display | LCD with backlight |
| Alarms | Visual, audible, and vibrating alarms |
| Battery Type | Rechargeable Lithium-ion battery |
| Sensor Type | Electrochemical |
| Gas Detected | Volatile Organic Compounds (VOCs) |
| Detection Range | Varies by gas type |
| Data Logging | Yes |
| Battery Life | Up to 24 hours |
| Operating Temperature | -20°C to 50°C (-4°F to 122°F) |
| Operating Humidity | 0 to 95% RH |
| Connectivity | USB for data transfer |
| Certifications | ATEX, IECEx, UL, CSA |
Procedure to set the High Alarm level for the ToxiRAE Pro.
Procedure to set the Low Alarm level for the ToxiRAE Pro.
Setting up the Man Down Alarm feature, including its operation and notifications.
Configuration of wireless parameters like Radio On/Off, PAN ID, Channel, and Join Network.
Procedures for configuring policy enforcement settings using ProRAE Studio II.
Specific steps for setting policy enforcement using the AutoRAE 2 Cradle.
Steps for setting policy enforcement using a desktop cradle or travel charger.
Details on 'Must Calibrate' and 'Must Bump' options and their bypass settings.
Instructions for bump testing and calibrating using the AutoRAE 2 Automatic Test and Calibration Station.
Steps for performing a functional bump test on the ToxiRAE Pro in Normal Mode.
Step-by-step guide on how to connect the calibration adapter to the ToxiRAE Pro.
Steps to change the span gas concentration used for calibration.
Steps to enter Diagnostic Mode, including password entry.
Detailed steps for safely removing and replacing the ToxiRAE Pro's Li-ion battery.
Information on the proper disposal of the product's battery according to WEEE directive.
Instructions for gently removing and installing a new sensor module, followed by calibration.
Information on ToxiRAE Pro marking, IECEx, ATEX, CSA certifications, and operating conditions.
To Next Page
