Rae ToxiRAE Pro - Available Electrochemical Sensors

ToxiRAE Pro User’s Guide
8
3. Available Electrochemical Sensors For ToxiRAE Pro
The following sensors are available for use in the ToxiRAE Pro.
Note: When replacing a sensor (even with the same type), the sensor may require
conditioning before first use, in addition to typical warm-up time prior to normal
operation. This can take from a few minutes to 24 hours, depending on the type of sensor.
Refer to RAE Systems Technical Note TN-151 for information on electrochemical sensor
replacement and maintenance.
Sensor
Range
Resolution
Ammonia (NH
3
)
0 to 100 ppm
1 ppm
Carbon Monoxide (CO)
0 to 500 ppm
1 ppm
Carbon Monoxide (CO),
Extended Range
0 to 2,000 ppm
10 ppm
Carbon Monoxide (CO),
H
2
Compensated*
0 to 2,000 ppm
10 ppm
Chlorine (Cl
2
)
0 to 50 ppm
0.1 ppm
Chlorine Dioxide (ClO
2
)
0 to 1 ppm
0.03 ppm
Ethylene Oxide (EtO-A)
0 to 100 ppm
1 ppm
Ethylene Oxide (EtO-B)
0 to 10 ppm
0.1 ppm
Ethylene Oxide (EtO-C),
Extended Range
0 to 500 ppm
10 ppm
Hydrogen (H
2
)*
0 to 1,000 ppm
2 ppm
Hydrogen Chloride (HCl)*
0 to 15 ppm
0.2 ppm
Hydrogen Cyanide (HCN)
0 to 50 ppm
0.5 ppm
Hydrogen Fluoride (HF)*
0 to 10 ppm
0.1 ppm
Hydrogen Sulfide (H
2
S)
0 to 100 ppm
0.1 ppm
Hydrogen Sulfide (H
2
S),
Extended Range
0 to 1,000 ppm
1 ppm
Methyl Mercaptan
(CH
3
-SH)
0 to 10 ppm
0.1 ppm
Nitric Oxide (NO)
0 to 250 ppm
0.5 ppm
Nitrogen Dioxide (NO
2
)
0 to 20 ppm
0.1 ppm
Oxygen (O
2
)
0 to 30% Vol.
0.1% Vol.
Phosgene (COCl
2
)*
0 to 1 ppm
0.02 ppm
Phosphine (PH
3
)
0 to 20 ppm
0.1 ppm
Phosphine (PH
3
),
Extended Range*
0 to 1,000 ppm
1 ppm
Sulfur Dioxide (SO
2
)
0 to 20 ppm
0.1 ppm
* Check with RAE Systems for availability.