Rae MultiRAE Plus PGM-50/4 - Programming Mode; Programming Menu Navigation

Program Mode
19
In addition to calibration, authorized users may change the monitor
settings to their requirements using the Programming Mode.
NOTE:
Monitoring gas concentrations continues during Programming
Mode, but pauses during Calibration. Datalogging also pauses during
Programming Mode, but resumes when programming is finished.
Press
for desired menu
to answer “no”
to decrease a digit
Press
for desired submenu
to answer “yes”
to increase a digit
Press
to return to the sensor name/
instantaneous reading display
to exit a submenu
to advance digits
To enter the Program Mode, press
M
and [N/-] together until the first
program menu appears: “Calibrate Monitor?”
Refer to Getting Started on
page 5.
The figure on the following page summarizes the programming
menus and how to navigate through them.
Programming Mode
Y/+
N/-
MO DE
N/-
MO DE