Rae MultiRAE Plus PGM-50/4 - Change Monitor Setup

24
Program Mode
Change Monitor Setup
Change the monitor setup or enter user information for the monitor. Use
M to move the cursor from character to character. Use [Y/+] and [N/-]
to toggle up and down the alphabet and numbers. To save, press M
until “Save?” appears. Press [Y/+] to save changes, otherwise, press
[N/-] to discard changes. To escape this menu without saving changes,
press and hold M .
Change Site ID?
Enter an eight-character alphanumeric site identification, which is
included in datalog reports.
Change ID Mode?
Set up an identification code to use during start-up or to access a
previously saved customized ID.
Change User ID?
Enter an eight-character alphanumeric user identification, which is
included in datalog reports.
Change Alarm Mode?
Choose either latched or automatic reset. The user must manually
acknowledge a latched alarm by pressing [Y/+]
.
Change User Mode?
The three different user modes are: Text, Display and Advanced.
Change Real Time Clock?
Change or update the real time clock and calendar.
Change Back Light Mode?
Automatic
– the monitor turns the back light on/off when ambient
light falls below/above the threshold
or
Manual
or Manualor
– press [N/-] to turn
the back light on/off.
Change Password?
Modify the password.
MO DE
MO DE
N/-
Y/+
Y/+
Y/+
N/-
MO DE
N/-