To reduce the risk of electric shock, turn off power before
removing the monitor cover. Disconnect the battery before
removing sensor modules for service. Never operate this
monitor while the cover is removed. Remove monitor cover
and sensor modules only in an area known to be non-
When the MultiRAE Plus monitor is taken out of the transport
case and is turned on for the first time, there may be some
residual vapors trapped inside the monitor and the initial
toxic gas sensors may indicate a few ppm. After running the
monitor for several minutes in clean air, the residual vapors
should clear and readings should return to near zero.
Attention! For European Applications
DEMKO 03 ATEX 0308256X, EEx ia d IIC T3/T4
B. Recharge batteries in non-hazardous locations.
C. Do not connect external cable to serial interface jack in
D. Use RAE Systems Adapter P/N 500-0072 for connection
to communication port and charging jack only in a non
Protected by U.S. Patents
5,773,833 , 6,225,633 , 6,313,638 , 6,333,632 , 6,320,388
This manual must be carefully read by all individuals who
have or will have the responsibility of using, maintaining, or
servicing this product. The product will perform as designed
only if it is used, maintained, and serviced in accordance
with the manufacturer’s instructions.
To Next Page
Loading...
Need help?
General
