EN
INSTALLING THE TIMER
1) Turn o the garden faucet.
2) Wrap Teon Tape around the faucet threads.
3) Screw the timer to the garden faucet and
make the display is as veical as possible to
the ground to prevent rainwater from
accumulating and leaking into the interior.
4) Wrap Teon Tape around the threads of the
timer outlets.
5) Screw the garden hoses to the timer outlets.
6) Turn on the faucet after programming the
timer.
Tips:
1) Wrap Teon tape around the threads
and align the threads for installation
to avoid thread wear and leakage.
2) If the faucet threads cannot tighten
to the bottom of the timer inlet, add
a rubber washer to create an end
seal to prevent leaks.
Please do not use tools, only install the timer by hand.
When freezing temperatures are expected, timers should be
removed from the hose faucet and stored indoors to prevent
potential freeze damage.
Please install the lter properly
and keep it clean as follows.
- 05 -
Rubber Washer
To Next Page
Loading...
