RAL STAINER
43
RAL STAINER User guide
Problem encountered Diagnosis Solution
Screen off The green and blue diodes visible
when powering on on the USB be port are on?
If yes Is the machine on standby? Press the standby button.
ON/OFF too fast? Turn off the appliance and then
turn it back on. If the system is
not restored, contact your RAL
Instruments representative.
If not Contact your RAL Instruments
representative.
The machine does not turn on?
Is the green diode that is visible
inside the machine when the arm is
in the soaking position in tank 3
on?
If yes Contact your RAL Instruments
representative.
If not You must changed the power Contact your RAL Instruments
supply or the fuse. representative.
No reaction No beep when pressing Turn off the appliance
of the touch screen impossible to enter the code. and turn it back on. If the system
is not restored, contact your RAL
Instruments representative.
Incorrect reaction Contact your RAL Instruments
on the touch screen representative
The codes do not allow Data loss Fill in the code
to go to the codes page to initialise the machine. If
the system is not restored,
contact your RAL Instruments
representative.
The machine does not Memory problem There is an SD card in the RFID
keep the codes in memory card located in the left reagent
loading door. Check that the
SD card is in the machine. If
necessary, remove it and replace
it after having cleaned the
connections.
Tag reading impossible Check whether the blue diode is on If the diode is on, try another
"Tag reading" very long the RFID card and check on the tag. If it persists impossible,
(greater than 10 seconds) info page whether the RFID software contact your RAL
is present. Instruments representative.
If the diode is off, contact your
RAL Instruments representative.
16.2 WHAT TO DO WHEN ...?
To Next Page
Loading...