R&S ESU Instrument Functions
Analyzer Mode
4.146 Operating Manual 1302.6163.12 - 03
MARKER
1|2|3|4 /
MARKER
NORM | DELTA
The MARKER 1/2/3/4.softkey selects the corresponding marker and activates it.
MARKER 1 is always the normal marker. After they have been switched on, MARK-
ERS 2 to 4 are delta markers that refer to MARKER 1. These markers can be con-
verted into markers with absolute value display by means of the MARKER NORM
DELTA softkey. When MARKER 1 is the active marker, pressing the MARKER
NORM DELTA softkey switches on an additional delta marker.
Pressing the MARKER 1 to 4 softkey again switches off the selected marker.
Example
Remote command: CALC:MARK ON
CALC:MARK:X <value>
CALC:MARK:Y?
CALC:DELT ON
CALC:DELT:MODE ABS|REL
CALC:DELT:X <value>
CALC:DELT:X:REL?
CALC:DELT:Y?
Side menu
MKR->TRACE
LINK MKR1 AND DELTA1
CNT RESOL ...
Side menu
STEPSIZE STANDARD
STEPSIZE SWP POINTS
MKR FILE EXPORT
DECIM SEP
[PRESET] R&S ESU is set to the default setting.
[MKR] On calling the menu, MARKER 1 is switched on ('1' highlighted in
the softkey) and positioned on the maximum value of the trace. It is
a normal marker and the MARKER NORMAL softkey is high-
lighted.
[MARKER 2] MARKER 2 is switched on ('2' highlighted in the softkey). It is auto-
matically defined as a delta marker on switching on so the DELTA
is highlighted on softkey MARKER NORM DELTA. The frequency
and level of MARKER 2 with reference to MARKER 1 are output in
the marker info field.
[MARKER
NORM DELTA]
The MARKER NORM DELTA softkey is highlighted. MARKER 2
becomes a normal marker. The frequency and level of MARKER 2
are output as absolute values in the marker info field.
[MARKER 2] MARKER 2 is switched off. MARKER 1 is the active marker for
entry. The frequency and level of MARKER 1 are output in the
marker info field.
To Next Page
Loading...
