R&S ESU Series - Differences in GPIB Behavior between the FSP and the FSE Families of Instruments

Operating Manual 1302.6163.12 - 03 6.289
R&S ESU Remote Control – Description of Commands
Differences in GPIB Behavior between the FSP and the FSE Families of Instruments
6.24 Differences in GPIB Behavior between the FSP and
the FSE Families of Instruments
The following list of commands contains the differences in syntax and behavior
between the GPIB command set of the FSP and the FSE families of instruments.
Firmware options are not described in this operating manual as the related com-
mands are not available in the basic instrument. FSE alone in column "Devices"
denotes the instrument families FSE, FSIQ, FSET and ESIB, unless otherwise
noted in column "Notes".
Devices Command (Sheet 1 of 47) Parameter Notes
R&S
ESU
FSE *CAL? R&S ESU: executes
total calibration
FSE: executes short
calibration
R&S
ESU
FSE *CLS
R&S
ESU
FSE *ESE
R&S
ESU
FSE *ESR?
R&S
ESU
FSE *IDN? model indicator and
version index is different
for R&S ESU and FSE
R&S
ESU
FSE *IST?
R&S
ESU
FSE *OPC?
R&S
ESU
FSE *OPT? list of available options is
slightly different for
R&S ESU and FSE, but
equally available options
have equal names
R&S
ESU
FSE *PCB
R&S
ESU
FSE *PRE
R&S
ESU
FSE *PSC
R&S
ESU
FSE *RST instrument settings are
slightly different for
R&S ESU and FSE due
to different instrument
specs
R&S
ESU
FSE *SRE
R&S
ESU
FSE *STB?