R&S ESU Series - 5 Entry of Scan Data

Operating Manual 1302.6163.12 - 03 4.55
R&S ESU Instrument Functions
Receiver Mode
4.5.5.5 Entry of Scan Data
SWEEP
Pressing the SWEEP key opens the menu to configure and start the scan.
A scan is defined in the form of tables or it is performed using the current setting.
In the SCAN table, the scan subranges are defined. Each scan range is specified by
start frequency, stop frequency, step width and the measurement parameters that
are valid for this range.
The scan can be performed as a single scan or continuously (softkeys SINGLE
SCAN and CONTINUOUS SCAN).
Scanning is started with the RUN SCAN softkey.
TDOMAIN SCAN |
STEPPED SCAN
!
ADJUST AXIS
INS BEFORE
RANGE
INS AFTER RANGE
DELETE RANGE
RANGES 1-5 | 6-10
FREQ AXIS
LIN | LOG
10dB MIN ON | OFF
RUN PRE-
SCAN+FINAL
RUN SCAN HOLD SCAN CONT AT REC
FREQ
CONT AT HOLD
STOP SCAN
STOP SCAN
USE CURR
SETTINGS
FIXED
FREQUENCY
SINGLE SCAN
CONTINUOUS
SCAN
FREQ AXIS
LIN | LOG
RUN PRE-
SCAN+FINAL
RUN SCAN HOLD SCAN CONT AT REC
FREQ
STOP SCAN CONT AT HOLD
STOP SCAN