Operating Manual 1302.6163.12 - 03 6.71
R&S ESU Remote Control – Description of Commands
CALCulate Subsystem
Example: "CALC:MARK:FUNC:POW:PRES BWLan"
Selects the standard setting for WLAN 802.11b.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-F
CALCulate<1|2>:MARKer<1...4>:FUNCtion:POWer:STANdard:CATalog?
This command returns all predefine ACP standards and all user standards. The numeric suffixes at
MARKer are irrelevant for this command.
Example: "CALC:MARK:FUNC:POW:STAN:CAT?”
'get all available ACP standards
Characteristics: *RST value:-
SCPI: device-specific
Mode: A
M2CDma CDMA2000 MC3 multi carrier with 3 carriers
TCDMa TD-SCDMA
AWLan WLAN 802.11a
BWLan WLAN 802.11b
WIMax WiMAX (Worldwide Interoperability for Microwave Access) IEEE 802.16-2004/Cor1-2005
WIBro WiMAX WiBro (Wireless Broadband) IEEE 802.16-2004/Cor1-2005
EUTRa E-UTRA/LTE Square
Use this standard setting to measure the assumed adjacent channel carrier configuration, E-UTRA of
same BW. In this mode, on all channels a square filter is applied.
REUTra E-UTRA/LTE Square/RRC
Use this standard setting to measure the assumed adjacent channel carrier configuration, 1.28, 3.84, 7.68,
Mcps UTRA. In this mode, a square filter is applied to the Tx channel and a RRC filter is applied to the
adjacent, alternate channels.
<string> <string> is the file name of a customized standard that has been saved with SAVE AS USER STD.
The settings for standards IS95A and C differ as far as the calculation method of
channel spacings is concerned. For IS95A and J-STD008 the spacing is calcu-
lated from the center of the main channel to the center of the corresponding adja-
cent channel, for IS95C from the center of the main channel to the nearest border
of the adjacent channel.
To Next Page
Loading...
