R&S ESU Remote Control – Description of Commands
CALCulate Subsystem
6.74 Operating Manual 1302.6163.12 - 03
Characteristics: *RST value: -120 dBm
SCPI: device-specific
Mode: A-F
CALCulate<1|2>:MARKer<1...4>:FUNCtion:STRack:TRACe 1 to 3
This command defines the trace on which the largest signal is searched for in the selected
measurement window. The function is independent of the selected marker, i.e. the numeric suffix
<1...4> of MARKer is irrelevant. It is only available in the frequency domain (span > 0).
Example: "CALC2:MARK:FUNC:STR:TRAC 3"
'Defines trace 3 in screen B as the trace for signal tracking.
Characteristics: *RST value: 1
SCPI: device-specific
Mode: A-F
To Next Page
Loading...
