Operating Manual 1302.6163.12 - 03 6.145
R&S ESU Remote Control – Description of Commands
MMEMory Subsystem
MMEMory:SELect[:ITEM]:ALL
This command includes all data subsets in the list device settings to be stored/loaded.
Example: "MMEM:SEL:ALL"
Characteristics: *RST value: --
SCPI: device-specific
Mode: R, A
This command is an event and therefore has no *RST value.
MMEMory:SELect[:ITEM]:CLISt ON | OFF
This command includes the scan channel list to be stored/loaded.
Example: "MMEM:SEL:CLIS ON"
'inserts the scan channel list to the list of partial data sets
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R, A
MMEMory:SELect[:ITEM]:DEFault
This command sets the default list of device settings to be stored/loaded. The latter includes:
• current configuration of general device parameters (general setup)
• current setting of the measurement hardware including markers
• activated limit lines
• user-defined color setting
• configuration for the hardcopy output
• activated transducers
• Final measurement data
• Tracking generator settings
(only in conjunction with option Tracking Generator B9 or External Generator Control B10)
• Correction data for source calibration
(only in conjunction with option Tracking Generator B9 or External Generator Control B10)
Trace data, non-used transducer factors/sets and non-used limit lines are not included.
Example: "MMEM:SEL:DEF"
Characteristics: *RST value: --
SCPI: device-specific
Mode: R, A
This command is an event and therefore has no *RST value.
To Next Page
Loading...
