Operating Manual 1302.6163.12 - 03 6.177
R&S ESU Remote Control – Description of Commands
SENSe Subsystem
6.16.7 SENSe:FMEasurement Subsystem
This subsystem controls the parameters of final measurement.
[SENSe<1|2>:]FMEasurement:THReshold[:STATe] ON | OFF
This command switches the threshold scan function (direct final measurement during the scan) on and
off.
Example: "FME:THR ON "
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R
[SENSe<1|2>:]FMEasurement:NBBB[:STATe] ON | OFF <numeric_value>:
This command switches on automatic detection of narrowband and broadband interference signals.
The detector for the final measurement is also automatically selected.
Example: "FME:NBBB ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R
[SENSe<1|2>:]FMEasurement:NBBB:LEVel <numeric_value>:
This command enters the decision threshold to discriminate between broadband and narrowband
interference.
Example: "FME:NBBB:LEV 6 DB "
Characteristics: *RST value: 6 dB
SCPI: device-specific
Mode: R
[SENSe<1|2>:]FMEasurement:AUTO ON | OFF
This command switches between automatic and interactive final measurement.
Example: "FME:AUTO ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R
To Next Page
Loading...
