R&S ESU Series - Page 636

Operating Manual 1302.6163.12 - 03 6.197
R&S ESU Remote Control – Description of Commands
SENSe Subsystem
[SENSe<1|2>:]MPOWer:RESult:MIN?
This command queries the minimum power value in a multiple burst power measurement as
configured and initiated with SENSe:MPOWer[:SEQuence]. The unit used for the return values is
always dBm.
If no measurement result is available, the command will return a query error.
Example: *ESE 1
*SRE 32
'Configuration of status reporting systems for the generation of an SRQ on
operation complete
SENSe:MPOWer
935.2MHz,1MHz,434us,VIDEO,50PCT,5us,MEAN,20;*OPC
'Configuring and starting the measurement
...
'Further actions of the control computer during measurement
On SRQ:
'Response to service request
SENSe:MPOWer:RESult:MIN?
Characteristics: *RST value: --
SCPI: instrument-specific
Mode: A-F, A-T