R&S ESU Series - Page 684

Operating Manual 1302.6163.12 - 03 6.245
R&S ESU Remote Control – Description of Commands
SYSTem Subsystem
Characteristics: *RST value: 0
SCPI: device-specific
Mode: R, A
SYSTem:TIME 0 to 23, 0 to 59, 0 to 59
This command sets the internal clock. The sequence of entry is hour, minute, second.
Example: "SYST:TIME 12,30,30"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
SYSTem:VERSion?
This command queries the number of the SCPI version, which is relevant for the instrument.
Example: "SYST:VERS?"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
This command is a query and therefore has no *RST value.
SYSTem:MSIZe? MBOard
This command outputs the memory size of the mainboard.
Parameter:
Example: "SYST:MSIZ? MBO"
Outputs the memory size of the mainboard.
Characteristics: *RST value: --
SCPI: device-specific
Mode: R, A
SYSTem:RSWeep ON | OFF
This command controls a repeated sweep of the E1 and MKPK HI HP model commands. If the
repeated sweep is OFF, the marker is set without sweeping before.
Example: "SYST:RSW:ON"
'Sets the repeated sweep on.
Characteristics: *RST value: --
SCPI: device-specific
Mode: R, A
MBOard Mainboard