R&S ESU Remote Control – Description of Commands
GPIB Commands of HP Models 856xE, 8566A/B, 8568A/B and 8594E
6.286 Operating Manual 1302.6163.12 - 03
RQS Supported bits:
1 (Units key pressed)
2 (End of Sweep)
3 (Device error)
4 (Command complete)
5 (Illegal command)
SRCNORM
SRCPWR
SP Default value, range, step size
SS Default value, range, step size
ST Default value, range, step size
STB The status bits are mapped as described with command RQS.
Bit 2 and 4 are always set in parallel if "Command Complete" or "End of Sweep"
are recognized. The R&S ESU cannot distinguish between these conditions. Addi-
tionally these bits are not suitable for synchronization on the end of sweep in con-
tinuous sweep operation.
TA Output of 1001 trace points of trace A in O1 or O3 format.
TB Output of 1001 trace points of trace B in O1 or O3 format.
TH Default value
VB Range
VBR Default value
Command Known Differences
To Next Page
Loading...
