R&S ESU Series - Page 746

Operating Manual 1302.6163.12 - 03 6.307
R&S ESU Remote Control – Description of Commands
Differences in GPIB Behavior between the FSP and the FSE Families of Instruments
FSE CONFigure[:MS]MEASurement? not available for
R&S ESU and FSET
FSET DIAGnostic:INFO:CCOunt:ATTenuation? not available for
R&S ESU
FSE DIAGnostic:INFO:CCOunt:ATTenuation<1 | 10>? not available for
R&S ESU
FSIQ DIAGnostic:INFO:CCOunt:ATTenuation<1 | 2 | 3>? not available for
R&S ESU
ESIB DIAGnostic:INFO:CCOunt:ATTenuation<1|2|4>? not available for
R&S ESU
FSE DIAGnostic:INFO:CCOunt:PRESelector<1..6>? not available for
R&S ESU
R&S
ESU
DIAGnostic:SERVice:CSOurce[:POWer] <numeric_value> new function for
R&S ESU
FSE DIAGnostic:SERVice:FUNCtion <numeric_value>,
<numeric_value> to
not available for
R&S ESU. Replaced by
DIAG:SERV:SFUNction
FSET DIAGnostic:SERVice:HGENerator OFF | 10 kHz | 100 kHz |
BALanced
not available for
R&S ESU
R&S
ESU
DIAGnostic:SERVice:HWINfo? new function for
R&S ESU
R&S
ESU
FSE DIAGnostic:SERVice:INPut[:SELect] CALibration | RF
R&S
ESU
DIAGnostic:SERVice:INPut:PULSed[:STATe] ON | OFF new command for
R&S ESU
R&S
ESU
DIAGnostic:SERVice:INPut:PULSed:PRATe <numeric_value> new command for
R&S ESU
R&S
ESU
FSE DIAGnostic:SERVice:NSOurce ON | OFF
R&S
ESU
DIAGnostic:SERVice:SFUNction <string> to replacement for DIAG:
SERV:FUNC of
R&S ESU;
necessary due to
different parameter
formats needed on the
R&S ESU
R&S
ESU
DIAGnostic:SERVice:STESt:RESult? new function for
R&S ESU
R&S
ESU
FSE DISPlay:ANNotation:FREQuency ON | OFF
DISPlay:BARGraph:LEVel:LOWer not available for
R&S ESU
DISPlay:BARGraph:LEVel:UPPer not available for
R&S ESU
R&S
ESU
FSE DISPlay:CMAP<1...26>:DEFault<1|2> larger selection of
independently
configurable items (1 to
26)
Devices Command (Sheet 19 of 47) Parameter Notes